...e there's a aftermarket wire harness with a small control box that activates the AUX input on the CD player
any similar products suitable for this a... Posted by on 25 October 2010 | Relevance: 0.6
...laybye, switched the car off, restarted the car and both faults cleared. Does anyone think it could be just the ammount of water that was about. Posted by ronos on 27 October 2010 | Relevance: 0.6
...w I did it, but somehow get her up to 103, set my cruise and things settled down with the lurching as soon as I took my foot off the accelerator.
... Posted by on 28 October 2010 | Relevance: 0.6
... that I can disable the reversing sensor with the switch, I'm more interested in being sure that the car was put on the Lexia and told that a wiring k... Posted by Activa on 07 November 2010 | Relevance: 0.6
...ht on the display at night, other than the dimmer switch on the display or reduce the info on the display, i.e. a night time function?
I thought tha... Posted by on 10 November 2010 | Relevance: 0.6
...e pneumatic suspension deflating when the car was switched off. Do these often fail on the C4GP as these are obviously much newer cars? Does the self-... Posted by danherts on 12 November 2010 | Relevance: 0.6
...e door using the key without a problem but when I switched the ignition on it didn't do its "boot up" routine (rev counter swinging round, warning lig... Posted by Dick L on 14 November 2010 | Relevance: 0.6
...nge when full? And what's the car like on a 75mph cruise?
Currently in my mapped C4 1.6HDi 110 when it gets filled (about £68) range says 900mil... Posted by on 15 November 2010 | Relevance: 0.6
...vetla%20obelezeno.jpg
It's on the bar where you switch your lights and turn signal (blinkers).
Can it be programmed via Lexia?
Sorry if someb... Posted by fellow on 17 November 2010 | Relevance: 0.6
... unit and found that what appears to be an output controller chip on the BSI circuit board has blown / burnt out. I suspect that this is as a result o... Posted by on 17 November 2010 | Relevance: 0.6
...llowed the ECU to re-boot). But now the Immobilizer warning sign comes on every time the ignition is switched on again after being turned off. Posted by on 18 November 2010 | Relevance: 0.6
...ion of the handbrake. I would say its simply the switch will need seating properly, but its nothing major - where is it though?
2) More panic-in... Posted by on 23 November 2010 | Relevance: 0.6
...ou are meant to be able to use the steering wheel controls to operate the phone or not.
The bottom left side of the steering wheel control button... Posted by on 25 November 2010 | Relevance: 0.6
... but £120 for harnesses adaptors to make all the controls to work and still cant change the time in my car as its a SX model. For £20 im a bit skept... Posted by on 26 November 2010 | Relevance: 0.6
...ork out where the switch is that tells the car that the boot is open.
I would be grateful if someone could point me in the right direction. Posted by matk on 27 November 2010 | Relevance: 0.6
...y and it seems as if the ECU does not have proper control over it.
I assume it has air in the system.
Is there a bleed procedure for these... Posted by JohnC4GP on 27 November 2010 | Relevance: 0.6
...ke a grinding noise when I went to brake.
Is this the traction control stopping the brake working as to tap on and off to reduce skidding? Posted by Shaneygreen on 27 November 2010 | Relevance: 0.6
...d a lay-by which wasn't too clogged up with snow, switched off the engine, waited 30 seconds and turned the key back on. The handbrake reset and was ... Posted by on 03 December 2010 | Relevance: 0.6
...t can also be noticed at some rain.
It tried switching off the main beam and switching on the fog lights the other day. What a difference! With m... Posted by on 04 December 2010 | Relevance: 0.6
As part of thread: Aftermarket parking sensors, dash display.
With Graphics from: Dave Forum Icons by Axialis Emotes by Seb