...ulty wiring loom on the rear brakes, faulty brake switch or battery going west, so I am putting two and two together; having checked the thread on how... Posted by FrankBullitt on 12 March 2013 | Relevance: 0.6
...While the car was in they tried changing the door switch unit. The window goes down OK, although sometimes only by holding the switch. It doesn't alwa... Posted by Jonzjob on 20 April 2013 | Relevance: 0.6
I have never understood how the car knows what gear it is in! Are there sensors or position switches in the gearbox, or does the system compare road s... Posted by routemaster1 on 03 March 2017 | Relevance: 0.6
...ar past 140kmh, then released throttle paddle and switched to 6th gear... during that deceleration phase car has also shown error, although not after ... Posted by Daniel_Cro on 06 April 2017 | Relevance: 0.6
...he bushes.
Other possibilities are the lower control arm bushes, suspension top mount bushes. Both of those are common to cause knocking noises i... Posted by danlat1415 on 11 July 2024 | Relevance: 0.6
You can still accelerate when cruise is set.. What you are thinking is of a limiter! Where it stops you going any faster than the set speed. Posted by phil7793 on 14 July 2013 | Relevance: 0.6
...tter. Without fail, I get the "check oil" message when switching the car back on. Always sorts itself out within a few minutes of getting going. Posted by CamM on 05 March 2013 | Relevance: 0.6
...eas: ABS/ESP ECU, Main Harness, Auto Transmission Control Harness, Engine ECU
P1713 - Clutch actuator position signal fault - suspect areas: Clut... Posted by Dave_Retired. on 25 August 2011 | Relevance: 0.6
... The most important but really is the oil you've use a C2 spec? If it's not! Then you could get big problems with the emission control systems. Posted by Mistermena on 15 November 2016 | Relevance: 0.6
...aulty pressure switch
There are threads on both.
STOP Oil pressure to low: http://c4owners.org/plugins/forum/forum_viewtopic.php?97127 Posted by Dave_Retired. on 01 August 2012 | Relevance: 0.6
...nd the parking sensor (>P<). scrolling up-down controls the panel light level, but if you push it it does nothing, or does it?
thanks again... Posted by george2 on 16 September 2013 | Relevance: 0.6
The latest roller switches are not just "up" and "down" but also have a "push" for OK/Select action.
AFAIK the lower left has no current function... Posted by BigJohnD on 17 September 2013 | Relevance: 0.6
The latest roller switches are not just "up" and "down" but also have a "push" for OK/Select action.
AFAIK the lower left has no current funct... Posted by george2 on 17 September 2013 | Relevance: 0.6
... C4 roller skating robot!!...
Half Moon - turn off all but outside speedo lights (dash, radio, switches, etc) really useful on motorways... Posted by PaulSc on 02 January 2014 | Relevance: 0.6
...tem fitted and also couldn't work out how to sort switch off the audible traffic warnings - quoted from the article:
"Annoyingly, the audible tra... Posted by bluehdi on 22 October 2010 | Relevance: 0.6
There is an easy solution fr this problem:
Switch off the TP function in the radio settings menu
Problem solved Posted by on 23 October 2010 | Relevance: 0.6
...milar, then it's a manual gearbox with electronic control. A good design idea, but in practice unreliable.
The (GM) design has two motors to shi... Posted by on 14 April 2012 | Relevance: 0.6
...Di's glow plugs fire up more frequently.
The control unit for the glow plugs has been known cause a few problems though.
Hopefully your engi... Posted by BigJohnD on 01 April 2015 | Relevance: 0.6
...ry by revalving and control changes for the rear air suspension if that is what you have fitted. Fronts will require new hardware.
regards Posted by gmerry on 13 April 2016 | Relevance: 0.6
As part of thread: "Parking brake fault" on startup
With Graphics from: Dave Forum Icons by Axialis Emotes by Seb