...s actually a manual gearbox. Just with a computer controlled clutch. Hence why you should lift between gear changes in an EGS. Do that and you won't f... Posted by wozza on 16 June 2010 | Relevance: 0.6
....
Also for your information, on dark when I switch off the engine, guide me home lights are staying for 30 seconds, but still can't operate with... Posted by beni_peja on 10 June 2019 | Relevance: 0.6
...r - alarm and from there disable boot opening using high frequency remote control option.
Thanks from everyone for your time.
Cheers Posted by beni_peja on 17 June 2019 | Relevance: 0.6
Thanks for the advice Munny, I did what you told me and it half worked I can now open the door from inside. I think its the master switches on the dr... Posted by brianking on 10 November 2017 | Relevance: 0.6
...connections, bluetooth; quadlocks, steering wheel control looms and aerial masts masts etc.
Nice to get it sorted without paying a dealer or gara... Posted by Grumpy GrandPa on 30 April 2014 | Relevance: 0.6
Hi,
Sorry if this seems a silly question and apologise in advance if this is obvious!
When using climate control, do I push on a/c and t... Posted by routemaster1 on 05 June 2017 | Relevance: 0.6
... the selector forward will soon show you which one is the right way!
Can't do this either on C4GP or C3. The switch does not move forwards. Posted by routemaster1 on 25 November 2014 | Relevance: 0.6
...or C3. The switch does not move forwards.
I've just tried and it doesn't move forward in the VTS either. Maybe you can't stop them folding. Posted by FakeConcern on 25 November 2014 | Relevance: 0.6
Yes, there fine in the position they are for left hand drive but the hazard switch really should have been swapped for right hand drive Posted by Dave_Retired. on 07 February 2009 | Relevance: 0.6
...60203_dashswitches.jpg
{e_PLUGIN}forum/attachment/82/1260365236_82_FT60203_dashswitchesreversed.jpg
(Apols for slapdash Photoshopping) Posted by BigJohnD on 09 December 2009 | Relevance: 0.6
In the door pull part there is a torx screw that goes down into the door card to retain the switch.
Remove the screw and lift at the rear edge as... Posted by Dave_Retired. on 14 December 2012 | Relevance: 0.6
Don't think it's very easy at all because as well as ducting it will require wiring and controls
Probably easier and cheaper to trade the car I'm... Posted by Dave_Retired. on 01 July 2012 | Relevance: 0.6
If the tailgate button just extends an earth, then an additional remote control relay could do that.
I used one of these to extend an earth on a ... Posted by wunny on 03 November 2017 | Relevance: 0.6
Admin Dave, its not like that i didn't understand any part. the things is, lock controlling liver is not there. but anyway, I have found my answer fro... Posted by love2drive on 19 October 2015 | Relevance: 0.6
... console.
Used meters to find the cable that controls the interior lights when door/boot is opened in the cable connector plug.
In my car it... Posted by Bin-The-L-Plates on 25 June 2012 | Relevance: 0.6
...are ref's and everything.
2.0HDi's do tend to be Siemens though (SID803 /803A IIRC) later ones switched to Delphi.
1.6HDi's are Bosch. Posted by Phil on 12 August 2010 | Relevance: 0.6
On UK spec cars, the LED lights act as the sidelights (sorry I don't know what the term is in Norway) but at reduced brightness. So if you switch to t... Posted by routemaster1 on 23 February 2017 | Relevance: 0.6
using the translator...
There's option in Diagbox to change it. Module BSI2010 -> Lighting - signaling -> "Simultaneous switching daytime running li... Posted by lodzman on 03 March 2017 | Relevance: 0.6
... it for your reference.
Biohead is correct, the point you posted an image of is where the bonnet switch goes if you have an alarm fitted :) Posted by Dave_Retired. on 02 May 2011 | Relevance: 0.6
As part of thread: I do not believe it!! Someone crashed into my GP! Nearside doors totalled!
With Graphics from: Dave Forum Icons by Axialis Emotes by Seb