Yes press in and hold the auto button on drivers temp controls and this will reset passenger side back to drivers control. Posted by HoneyMonster on 05 October 2010 | Relevance: 0.6
You can tell when it is under driver control as both the people will be filled in on the display. Instead of one filled in and the other having an out... Posted by wozza on 05 October 2010 | Relevance: 0.6
...the same (Auto mode, 18deg 18 deg) and are non-functional and no controlable by the original digital climate control unit with dual zone dials. Posted by on 21 July 2015 | Relevance: 0.6
...hich doesn't have a dedicated display for climate control, so the air-con/heater/defrost etc settings are displayed on the Type C multifunction displa... Posted by on 21 July 2015 | Relevance: 0.6
Going by the various quality control alerts I see, I would steer clear of anything that your life depends on and is made in China.
I was at a pre... Posted by Rich_Eason on 31 March 2010 | Relevance: 0.6
... on.
Is it the battery, is it the stop start switch?
Once it comes to life, all is fine until left for a few hours, then it's often back to ... Posted by wunny on 18 November 2025 | Relevance: 0.6
...stop button WITHOUT holding the brakes. This will switch on all the car's electronic equipment without igniting the engine.
2. Safety precaution:... Posted by Duck999 on 16 November 2017 | Relevance: 0.6
On the DS4, with rear wheels in the air, release the handbrake manually, dont start the engine as it'll apply the handbrake when you switch off.
... Posted by vexorg on 15 January 2021 | Relevance: 0.6
I am sitting here wondering if I detach the clutch cable at the pedal I might have just about enough room to place the switch but then again I am not ... Posted by Leonk9 on 05 March 2017 | Relevance: 0.6
Reiterate: Automatic handbrake faulty with ESP/ASR and ABS faults showing, replacing the brake switch has not worked, bought a lexia system which (aft... Posted by Battenburg on 14 September 2015 | Relevance: 0.6
...(If necessary).
Start the engine.
N.B.: Switch on the headlamps (For a minimum of 10 minutes) : The condensation disappears ; Do not replace... Posted by Dave_Retired. on 04 November 2013 | Relevance: 0.6
None if you already have a CD Multi Changer installed as I said.
It will work as soon as it's installed, when you press the mode switch it will a... Posted by Dave_Retired. on 02 December 2009 | Relevance: 0.6
...come and go between first and secondary circuit of brake fluid on ABS, ESP, and even switching ignition on.
what do you think ?
Shin Posted by MAKKOTTI on 03 June 2016 | Relevance: 0.6
AFAIK, the control unit is a simple exchange (but could be expensive).
Removal of the radio HU is easy and will give extra access. Posted by BigJohnD on 10 February 2011 | Relevance: 0.6
...justed by the switch?
The suspension on a C4GP exclusive is normally on the soft side, I for one like the ride especially on long journeys. Posted by tomandjo2 on 05 August 2015 | Relevance: 0.6
I've mastered the rear ride height switches now and the car never leaves my drive in anything but the default position ...BTW what's the point of the ... Posted by DaveJFT on 05 August 2015 | Relevance: 0.6
Had a quick look, but cannot locate the switches I'm afraid so can't confirm if it's a block or not but you certainly can't buy the switch tops from C... Posted by Dave_Retired. on 22 February 2014 | Relevance: 0.6
... door, 2 at the rear. And 1 in the panel with the controls.
Remove control panel first, undo screw and pull from the hand pull section up first. ... Posted by wozza on 13 November 2014 | Relevance: 0.6
...ne do a unit for this that will do both the steering controls and the display has anyone sourced this or am I the first to be awkward
Cheers Posted by Madspark on 05 May 2015 | Relevance: 0.6
As part of thread: Reset passenger temperature
With Graphics from: Dave Forum Icons by Axialis Emotes by Seb