Sorry it didn't work for you, mine still working after about 3 weeks!
With the engine running and radio off if you change control settings ie fan... Posted by oscarlab on 17 December 2015 | Relevance: 0.6
...rs side was a bit of a pain because of the window controls. Unscrewed the old speakers and fitted the new ones and thought everything was good. That w... Posted by Losty on 11 November 2017 | Relevance: 0.6
Each door has a switch on it, if one of these has a fault then this could be your problem. You could try holding the door buttons in with your fingers... Posted by hertsnminds on 09 September 2010 | Relevance: 0.6
...e child locks on and found in the manual that the switch is behind a rubber grommet which appears initially to have a key hole in it that you needed t... Posted by PaulSc on 01 August 2012 | Relevance: 0.6
just noticed that the adjustment for mirror from inside switch is not working fuse? any idea where i would find it Posted by Westentertainer on 25 January 2021 | Relevance: 0.6
its both sides from the one switch the automatic folding is working though but not the mirror adjustment or auto dip on reverse Posted by Westentertainer on 25 January 2021 | Relevance: 0.6
disable the electric mirror function by holding the centre of the mirror switch down for about five seconds, also ask them which section of the MOT te... Posted by GPGeorge on 06 June 2019 | Relevance: 0.6
...s far as I can make out there is no option at the switch. I have also checked on our C3, and there is no option on that either. I have looked through ... Posted by routemaster1 on 01 August 2014 | Relevance: 0.6
...sors and integrate via CAN BUS like factory fitted OEM ones I'm afraid.
They will need to be a separate installation and manually switched. Posted by Dave_Retired. on 05 March 2011 | Relevance: 0.6
...ont sensors but I just wanted to know how the OEM sensors operator? Like where the switch, whats it used for and has anyone brought the Dolphin? Posted by kwan_88 on 05 March 2011 | Relevance: 0.6
...know how the OEM sensors operator? Like where the switch, whats it used for and has anyone brought the Dolphin?
On my OEM ones, the switch ... Posted by Ivan_C4P on 05 March 2011 | Relevance: 0.6
Excellent, I reckon I can buy the Canbus kit and then the switch from the dealer and it should look like almost OEM usage for the sensors. Posted by kwan_88 on 05 March 2011 | Relevance: 0.6
Excellent, I reckon I can buy the Canbus kit and then the switch from the dealer and it should look like almost OEM usage for the sensors.
... Posted by Ivan_C4P on 05 March 2011 | Relevance: 0.6
...e would be almost OEM sensors.
Does any know how much the OEM front parking sensor switch costs? Or any cheap OEM websites for parts?
Posted by kwan_88 on 05 March 2011 | Relevance: 0.6
I didn't think there was a separate switch for the front and rear sensors. There's certainly not enough room for separate switches on the coupe (4 sp... Posted by Biohead on 05 March 2011 | Relevance: 0.6
I see, then it should be ok to connect and just pick up the standard speed message to enable the sensors :)
Regarding switch panels, not sure ... Posted by Ivan_C4P on 06 March 2011 | Relevance: 0.6
... the Dolphin kits???
Just checking but was the red rocker switch to disable the front sensors? Or to disable the rears?/
Thansk again. Posted by kwan_88 on 06 March 2011 | Relevance: 0.6
...kits???
Just checking but was the red rocker switch to disable the front sensors? Or to disable the rears?/
Thansk again.
The curren... Posted by routemaster1 on 06 March 2011 | Relevance: 0.6
...he fuel flap release is on a 2008 1.6 petrol model and if I wanted an OEM switch I would need to replace the whole blanking panel.
Regards. Posted by kwan_88 on 06 March 2011 | Relevance: 0.6
As part of thread: Dreaded heater problem
With Graphics from: Dave Forum Icons by Axialis Emotes by Seb