Sounds like a dodgy drivers door switch. The only way to sort it would be to replace the switch.
Why not pop to GW bridges at Pease Pottage to s... Posted by rusky on 18 January 2014 | Relevance: 0.6
Sounds like a dodgy drivers door switch. The only way to sort it would be to replace the switch.
Why not pop to GW bridges at Pease Pottage t... Posted by Paperhouse on 18 January 2014 | Relevance: 0.6
...t again while the engine is running. No need to slam the door - it's not a faulty switch or loose connection. Then the window will work again. Posted by Paperhouse on 05 February 2014 | Relevance: 0.6
...oor opening. The dealer changed the driver's door switch panel (was on second hand car warranty) but it didn't fix the fault. Seems to be a BSI proble... Posted by VTRPLUS27 on 07 February 2014 | Relevance: 0.6
Are your brake light always on? I had a case when I didnt correctly put brake light switch behind pedal. My brake lights were always on, and car didn'... Posted by Ap0qalypto on 21 November 2022 | Relevance: 0.6
...possibly the passenger on a RHD car).
It's in the menu accessed via the steering wheel controls. Check there before taking door cards off! Posted by rusky on 11 June 2016 | Relevance: 0.6
...ENSION METAL REAR PNEUMATIC
DYNAMIC STABILITY CONTROL SYSTEM ELECTRONIC STABILITY PROGRAM
BRAKE ASSOCIATED VARIANT 8 1 BOSCH ESP
Th... Posted by on 29 April 2012 | Relevance: 0.6
...The £26 seems a bit steep for the cable when the switch is only about £7. What is so special about the cable? I have also just been and checked if m... Posted by Dobbin on 05 February 2011 | Relevance: 0.6
Sorry to revive an old thread. I had a service light pop on and error message speed control fault.
Do I need to take it in and have a software u... Posted by mooresey on 14 June 2011 | Relevance: 0.6
It is a common fault but a very easy fix, i had the problem on mine tried the switch cleaner but that didnt work, replacing the switch is so easy thou... Posted by on 17 June 2011 | Relevance: 0.6
...ssue, so just a glitch, a bit like the depollution error I had last week which hasn't been seen again.
Probably just dirt in the switch.
Posted by BigJohnD on 26 June 2011 | Relevance: 0.6
Sonny, you say the switch is easy to replace. Are you talking about the brake switch under the glove box or the 'Lim' 'Reg' switch on the steering whe... Posted by Dobbin on 06 July 2011 | Relevance: 0.6
...door (on a dry day) in order to remove the handle/switch. I then sprayed silicone spray into the switch and all the connections. This seemed to fix th... Posted by Swebby on 08 March 2015 | Relevance: 0.6
I didnt have the euro socket on mine, but the same problem.
I managed to free the switch by stripping the socket. Posted by Ham on 21 January 2012 | Relevance: 0.6
... pin socket that I have procurred also has a microswitch so the car BSI (via initialised towing ECU) will now when the boat trailer is attached.
... Posted by gmerry on 03 February 2012 | Relevance: 0.6
Hi all, finally got around to removing the faulty 13pin Euro towing socket.
There had been an electrical fault inside the microswitch which has c... Posted by gmerry on 31 March 2012 | Relevance: 0.6
...anbus wires correct (the ones that go to the microswitch). There is a common terminal (earthed?), plus a wire each to normally open and normally close... Posted by gmerry on 04 April 2012 | Relevance: 0.6
The wiring of the D & C terminals on the micro-switch is absolutely critical. When I had a MK1 C5 there was no earth feed connection on the micro-... Posted by DavidC4 on 04 April 2012 | Relevance: 0.6
David, thanks again for your warnings.
The microswitch has three terminals:
Common (to earth), Normally Closed (no towing socket), Normall... Posted by gmerry on 05 April 2012 | Relevance: 0.6
As part of thread: Faulty nearside rear window
With Graphics from: Dave Forum Icons by Axialis Emotes by Seb