As part of thread: How do you remove door handles?
You have to opel the doors panel. 1)Remove the handle's trim 2)Remove the window controls 3)Remove the panel Then the door handle snaps ...
Posted by on 04 March 2010 | Relevance: 0.6

As part of thread: How do you bleed the Fuel System on a 62 plate C4GP 1.6 HDI?
...uel tank with at least five litres of Diesel. - Switch on the ignition (without starting the engine). - Wait around 6 seconds and switch off the i...
Posted by rafiki on 17 September 2015 | Relevance: 0.6

As part of thread: How do I switch the radio off?
Push the volume control in. Turns it on and off. Will come on and off with the ignition though.
Posted by wozza on 06 October 2010 | Relevance: 0.6

As part of thread: How do I switch the radio off?
...u can switch the display into night mode along with certain sections of the rest of the dash. I'm sure a similiar thing is possible on the C4P.
Posted by Phil on 06 October 2010 | Relevance: 0.6

As part of thread: How do I remove rearside door lining (card?)
...off) If all the screws are out, lift out the switch module starting at the trailing (rear) end, then start unclipping the door card at the bottom...
Posted by Dave_Retired. on 06 September 2013 | Relevance: 0.6

As part of thread: How do I check continuity of ABS sensor wire?
I have a 2010 Ford Escape with an ABS and Traction control light on the dash. Read the code and it said no input from front left sensor. Replaced the ...
Posted by salliborm12 on 02 March 2026 | Relevance: 0.6

As part of thread: How can I turn RDS off completely?
Which model radio? Which station? Which display? Look at the handbook for your model. My guess is you need to switch off AF (Alternative...
Posted by BigJohnD on 22 October 2014 | Relevance: 0.6

As part of thread: How can I tell if the car's computer has been told that the wiring kit is fitted?
On the 12n socket there should be a very small switch that is activated when you put the caravan/trailer plug into it. The one fitted to my car is o...
Posted by Ham on 07 November 2010 | Relevance: 0.6

As part of thread: How can I tell if the car's computer has been told that the wiring kit is fitted?
Ok, got the multimeter out and had a look at the 13 pin socket on the car. I have a permanent 12v feed on pin 9 but no ignition switched feed on pin 1...
Posted by Activa on 07 November 2010 | Relevance: 0.6

As part of thread: How can I tell if the car's computer has been told that the wiring kit is fitted?
...ed. Now it will only do this if the by-pass switch in the 12n socket is operated (due to the caravan being plugged in) AND the C4 has been progr...
Posted by Hoipoloi on 07 November 2010 | Relevance: 0.6

As part of thread: How can I tell if the car's computer has been told that the wiring kit is fitted?
...the software or there's a problem with the little switch on the 13 pin socket which signals that the caravan is plugged in. I also don't have power on...
Posted by Activa on 09 November 2010 | Relevance: 0.6

As part of thread: How can I tell if the car's computer has been told that the wiring kit is fitted?
...eversing sensors would no longer be automatically switched off on connecting a trailer, "that's what the dashboard switch is for"; and the bulb failur...
Posted by Activa on 18 November 2010 | Relevance: 0.6

As part of thread: How can I switch off economy mode and a gripe about the hand book.
...io switched on. It's booked to see the Citroen doctor next week, and yes they said it was an impossibility until it was demonstrated to them.
Posted by Magistrate on 11 April 2010 | Relevance: 0.6

As part of thread: How can I switch off economy mode and a gripe about the hand book.
...eally can be, but you learn to live with it. Switching the radio over to a permanent live feed to bypass economy mode may also be an issue for ca...
Posted by Dave_Retired. on 12 April 2010 | Relevance: 0.6

As part of thread: How can I switch off economy mode and a gripe about the hand book.
After half a hour or so with the engine switched off my radio goes dead along with all the other electrics, it tells me I'm in economy mode. As I ...
Posted by chrispatch on 14 April 2010 | Relevance: 0.6

As part of thread: How can I remove door handle?
... hole at the top by the multifunction elec window switch. i have these out as i have popped the panel about 50%, reached up and push the elec win...
Posted by on 23 December 2007 | Relevance: 0.6

As part of thread: How can I remove door handle?
... of the door pull which is part of the whole pull/switch assembly As wozza says there will be very few screws around the outer edge of the trim a...
Posted by Dave_Retired. on 23 December 2007 | Relevance: 0.6

As part of thread: How can I remove door handle?
...d...no elec windows, door will not lock. the switch is no good so off to a dealer to order one. have fitted an new bsi and car now starts an...
Posted by on 24 December 2007 | Relevance: 0.6

As part of thread: How can I remove door handle?
...have not checked others) has a seperate motor and control unit to the regulator. ridiculous amount of electronics to this. The cover with elect...
Posted by on 06 January 2008 | Relevance: 0.6

As part of thread: How can I move (roll) my C4P without starting the engine?.
Does switching on the ignition and pushing the handbrake switch not do it?
Posted by gittos on 23 August 2017 | Relevance: 0.6