or Login >>         
C4 - DS4 Owners :: Forums :: C4 Picasso and Grand Picasso - PRE 2013 only :: C4 Picasso Problems and issues

C4GP 2009 - EGS6 directed manual box, error P0991 fluid pressure sensor

Home   Forum Rules    Forum Help  Conversion Tools
   
Please Register to enjoy additional Member Benefits
Top Thanked Forum Posts: Today | Week | Month | Year | All time | Most Thanks Given: To member | By user
Author Post
mwj666   
Sat Nov 01 2025, 03:32am
Member No: #49862
Joined: Nov 13 2017
Location: Cheshire
Greetings all,

Partner's C4GP refused to go from 'A1' to 'N' a couple of days ago when trying to start it. Tried several times, same result. Went in to scratch head and do a bit of googling, found nothing, went back out an hour or so later and it instantly went from 'A1' to 'N' and started... duh! It's not recurred since. Battery is good so it's not a low voltage problem

Checked it out with diagbox the next day and it showed fault P0991, temporary loss of pressure sensor signal. An internet search revealed nothing helpful whatever so clearly not common

My suspicion is it's dirty contacts on the sensor connector as the car does nominal mileage and lives outside in all weathers but I haven't even been able to find out where the damn' switch lives so I can check and clean the connectors

Does anyone know:-
1. Whereabouts on the EGS6 box it sits (a diagram would be very handy!)
2. What the car's limp-home strategy is if it loses the signal permanently - does it just leave you stuck in whatever gear you are in at the time or does it (try to) go to neutral?

I've got docbackupAC but for some reason it doesn't want to open the 'repair procedure' that tells you how to replace the fluid pressure sensor (and hence whereabouts it is)

Any info gratefully received - thanks!
Ap0qalypto   
Sat Nov 01 2025, 06:32pm
Member No: #52161
Joined: Sep 21 2018
Location: Republic of Serbia
Cheap diagnostic will point to low pressure, even though it is only a Gear selector stalk. Car will go to N once you stop, even if hydraulic pump is not working.
Bottom line, issue is 99% at gear selector. My recommendation is to change it for the second hand one. Bear in mind that they have on them either A, B or M, so there are 3 types. Before buying, remove cover from selector and observe letter on it. Its just a plug and play, so no need to recalibrate anything. EGS doesn't need calibration even if you change clutch on it
 

Jump:     Back to top

User Colour Key:
Head Administrator, Administrator, Forum Moderator, Forum Moderator, Premier Member, Technical Expert, New C4 and DS4 Forum Moderators, Member